Table of Contents
Advertisement
Update the Drivers
1. Uninstall the driver
See "Uninstalling the Driver"(page18)
2. Install the driver
See step 2 through 5 on "Install the Drivers" (page17)
Note: Only step4, See below.
i)
Insert the Driver Disk in the CD drive.
ii)
Open [Device Manager] and double click [Multifunction adapters]-> [Ethernet Controller].
iii) Click [Driver] tab and click [Update Driver].
iv) Select [No, not this time] to [Hardware Update Wizard] and click [Next].
v)
Select [Install from a list or specific location (Advanced)] and click [Next]
vi) Select [Include this location in the search] and click [Browse] to specify the following folder
[<CD Drive letter>:¥CHELSIO]
Click [Next].
vii) The driver's installation will start after appropriateness module searching complete.
* By some condition [Hardware Installation] dialog will appear.
Click [Continue Anyway]
viii) [Found New Hardware Wizard] will appear. Click [Cancel].
ix) Click [Finish] to [Hardware Update Wizard].
x)
[Chelsio S310 10G Ethernet Function Enumerator] will appear in [Multifunction adapters]
after installation complete.
xi)
[!?Chelsio Network device] properties will appear under [Network adapters] tree. Right click
to open the [properties].
xii) Repeat iii) to vii) to install this device driver.
xiii) Click [Finish] to [Hardware Update Wizard]
19
Advertisement
Table of Contents
