NEC Express5800 Series Maintenance Manual page 131

Chapter 3 Appendix
(3) Error messages on a virtual LCD
In EXPRESSSCOPE Engine 3 web browser window, you can confirm virtual LCD error messages (for details on
the virtual LCD, refer to "EXPRESSSCOPE Engine 3 User's Guide").
The table below shows the error messages displayed on upper and lower lines, cause, and solution.

Messages displayed on an upper LCD line
BIOS Message on
Upper LCD Line
XX POST Started ...
XX BIOS Version
YYYY
POST Completed
Successfully
POST ERROR XXXX
No Available
Memory in System
Error Pause in POST POST detected an error and paused. Check the message displayed on LCD, and take
Entering BIOS
SETUP MENU
Waiting for normal
temperature
BIOS Recovery
Running
BIOS Updater
Running
Cause
Displayed while POST is running.
"XX" denotes POST code that is
running.
Displayed while POST is running.
"XX" denotes POST code that is
running, and "YYYY" denotes system
BIOS version.
Displayed when POST completes
normally.
Error XXXX was detected during
POST.
No available memory is installed.
Starting up BIOS SETUP MENU.
A temperature abnormality was
detected inside the server.
BIOS recovery is in progress.
BIOS update is in progress.
Express5800/E120d-1 Maintenance Guide
Message displayed on
upper LCD line
Message sent from BIOS
Message displayed on lower
LCD line
Message sent from BMC
Solution
This is not an error.
This is not an error.
This is not an error.
Check the message displayed on LCD, and take
an appropriate action.
Make sure that the memory is correctly installed.
If the same message is displayed repeatedly,
contact your sales representative.
an appropriate action.
This is not an error. This message will disappear
when SETUP operation is completed.
Lower the room temperature or turn off the
power to cool the server to room temperature
before starting up the server. If this abnormality
continues to occur, check if a fan has failed. If
the same error still continues to occur, contact
your representative.
This is not an error. Wait until BIOS recovery is
completed.
This is not an error. Wait until BIOS recovery is
completed.
1. POST Error Message
(1/2)
131