NEC Express5800 Series Maintenance Manual page 71

Chapter 2 Convenient Features
Option
Thermal Sensor
Check previous System
Config
BMC IRQ
Post Error Pause
Memory Error
Power Switch Inhibit
CLI SETUP
Parameter
Disabled Enable or disable the thermal sensor monitoring feature. If
[Enabled] this option is set to Enabled and when abnormal
temperature is detected, stops POST before OS starts
and waits until the temperature becomes normal.
[Disabled] Enable or disable the feature to detect system
Enabled configuration change.
If this option is set to Enabled and the system
configuration differs from the previous boot, the system
stops before OS booting and displays confirmation
message whether to continue booting. At this time, POST
pauses until user's response is made.
Disabled Specify whether to allocate interrupt lines for BMC
(Baseboard Management Controller).
[IRQ 11]
Disabled Enable or disable the feature to suppress OS booting
[Enabled] when POST detects an error, until user's response is
made.
When set to Disabled, continues OS booting regardless
of user's response even if an error is detected during
POST.
Halt Enable or disable the feature to suppress OS booting
[Boot] when POST detects a memory degradation error, until
user's response is made. This option is valid only when
POST Error Pause is set to Enabled. Even if this option is
set to Boot, POST stops to suppress OS booting if all of
thememory resources are degraded.
[Disabled]
Enable or disable the POWER switch inhibit feature.
Enabled
[Disabled] Enable or disable the Command Line Interface SETUP
Enabled feature. When this option is set to Enabled, the operation
of SETUP is changed to use Command Line Interface. To
switch back to the menu operation, set this option to
Disabled.
Express5800/E120d-1 Maintenance Guide
1. System BIOS
Descriptions
[ ]: Factory setting
(2/2)
71