Advertisement
Installation Reference
Installing the outdoor optical cable, and outdoor Ethernet cables
a: Rotate the expansion cap counterclockwise and
1
loosen it.
b: Open the socket clip.
c: Pull the socket downwards with force.
b
c
a
Expansion cap
3
Remove the blocks on the rubber plugs based on
the numbers of cable, and wrap the cable with
rubber plugs.
Splitter
Block
Push out the rubber plugs from the bottom of the
2
socket, route the outdoor optical fiber through the
bottom of the socket and insert it into the
corresponding port.
Rubber plug
Socket clip
This document uses outdoor optical fiber
installation as an example to describe the methods
of installing cables. Methods of installing the
outdoor Ethernet cables are the same as those of
installing the outdoor optical fiber.
After the equipment is installed and commissioned,
the methods and procedure for cable replacement
and expansion are the same as those described in
the figures.
Socket expansion caps and rubber plug are used
for anti-falling. Do not pull them off forcibly.
4
a: Push the socket upwards with force.
b: Fasten the socket clip.
c: Rotate the expansion cap clockwise and fasten it.
b
a
c
Installing the outdoor optical cable, and outdoor Ethernet cables
After the installation, ensure that the length of exposed rubber plug is about 10 mm.
5
Installing the DC cable
Corrosion-proof the DC cable connector.
For details, see the appendix.
14
If the OAU 2F (DC option) uses DC power, do not install
or remove a live power cable. Any contact between the
power cable core and a conductor can generate electric
arc or sparks, which may cause fire or eye injury.
Advertisement
