4.
Trigger condition settings (No need to change)
Set the trigger condition where necessary.
The default values are normally used.
1. Clicking [Edit] [Sampling Setting] [Trigger Setting] will display the "Trigger Setting" screen.
2. Select the Trigger Mode from Bit OR, Bit AND, Word OR, and NONE.
3. Select a pattern from options such as leading edge, trailing edge, change, etc.
5.
Start sampling
RUN: Start sampling.
STOP: Stop sampling.
FREEZE: Sampling pauses.
1.
2.
3.
RUN,STOP,FREEZE
4 SYNCHRONOUS CONTROL STARTUP
4.4 Operation Check for Synchronous Control
4
65