Connecting The Power Cable - HP A10500 Series Manual

Figure 21 Install a power supply in a horizontal slot
(1) Install the power supply to the chassis

Connecting the power cable

WARNING!
Before connecting the power cable, make sure that the circuit breaker on the power cable is switched off.
To connect the power cable:
Plug the power cable into the power receptacle of the power supply.
1.
Use a cable tie to secure the power cable to the cable management bracket.
2.
Figure 22
a.
A10508-V).
Figure 23
b.
Plug the other end of the power cable to the AC power receptacle of the power source and switch
3.
on the circuit breaker.
Check the power supply input status LED. If the LED is on, the power cable is properly connected.
4.
For description of power supply status LEDs, see the chapter "Appendix C LEDs."
shows how to connect the power cable for a vertical slot switch (A10508 and
shows how to connect the power cable for a horizontal slot switch (A10504).
28