Replacing A Card - HP A10500 Series Manual

Install a new power supply. For the installation procedures, see the chapter "Installing modules."
8.
WARNING!
x
To install the removed power supply to the chassis again, install it after the status LED on it is off.
x
The power supply may be of high temperature. Remove it with caution.
Figure 37 Remove the power supply
(1) Loosen the captive screw
CAUTION:
After removing the power supply, if you do not install a new power supply, install a blank panel.

Replacing a card

NOTE:
Remove the cables on an MPU or LPU before removing the MPU or LPU.
(2) Pull the power supply out
51