Table of Contents
Advertisement
Setup the Power Measuring Unit
STEP2
13
Connect the smartphone to the Gateway.
14
Switch the Gatewayʼs WLAN AP switch
to the ON position.
Tap the
"Next" button.
Check the Status LED on the rear of the Gateway is either lit or repeats
a double or triple flash, and set WLAN AP switch 1 to the OFF position,
and the back to the ON position. The Gateway will immediately enter
AP mode. Once in AP mode, the Application LED on the front of the
Gateway will flash in orange.
Application LED
If there are
no problems,
tap the
"Next" button.
19
Status LED
WLAN AP switch
It takes around 1 minute for the Gateway to
Note
boot after powering on.
Installer Tasks
Rear
Advertisement
Table of Contents
