Panasonic HOME IoT Installation Manual page 27

Check the wireless signal strength to the Home IoT Gateway
STEP4
1
Once all devices are installed,
tap the "Settings Complete"
button on the screen below.
3
Check the signal strength
to the Gateway.
Tapping the "Next"
button on the final
screen of
STEP1
displays the screen
to the left.
Tap the "Settings
Complete" button to
continue.
Please be patient as
the checking process
takes several
minutes.
27
2
Check the connection signal strength
for devices connected to the Gateway.
Incoming
Data Lamp (Red)
Refresh Button
4
Once checks are complete,
tap the "Everything is
normal" button.
Installer Tasks
* If a Power Measuring Unit
is installed, check the
signal with the consumer
unit cover closed.
* If a Temperature /
Humidity Sensor is
installed, hold the
Refresh Button on the
base of the sensor for at
least 3 seconds and
check that the Incoming
Data Lamp lights in red.
Once the above checks
are complete, tap the
"Check" button at the
bottom of the screen.
Confirm the output
on the screen to the
left. If there are no
problems, tap the
"Everything is
normal" button.
Note
If there are connec-
tion errors, adjust the
position of the
Gateway an try again.