Panasonic HOME IoT Installation Manual page 21

Setup the Power Measuring Unit
STEP2
16
The smartphone is
successfully connected
to the Gateway.
Go to the next step
Tap "Next" button to proceed to the next step.
*If not connedted to the Gateway properly,
an error screen will be displayed after tapping "Next" button.
18
Put the Power Measuring Unit into registration mode.
Tap the
"Next" button
to move to
the next step.
1. Once the Gateway is in registration mode, the Application
LED on the front of the Gateway will flash in green.
2. Hold the SET button on the Power Measuring Unit for at least
3 seconds to put it into registration mode.
Application
LED
3. Once the REGISTER LED on the Power Measuring Unit changes
from flashing to permanently on, registration is complete
(the LED will turn off after 5 minutes).
After completing the above process, tap the
"Check" button to confirm registration.
21
17
Put the Gateway into
registration mode.
Installer Tasks
Check that the
Application LED is
flashing in orange.
Tap the "Activate
Registration Mode"
at the bottom of
the screen to enter
the Gatewayʼs
device registration
mode.