Remote Control; Smartgrid - Miele WTR 860 WPM Operating Instructions Manual

- Reset
The setting is only visible if
Miele@home is set up.
The WiFi function is deactivated and
the WiFi connection will be reset to
the factory default.
The network configuration should be re-
set whenever a washer-dryer is being
disposed of or sold, or if a used
washer-dryer is being put into opera-
tion. This is the only way to ensure that
all personal data has been removed and
the previous owner will no longer be
able to access the washer-dryer.
A new connection setup has to be car-
ried out in order to use Miele@home
again.

Remote control

The Remote control
ible if the Miele@home
and activated.
If the Miele@mobile App has been in-
stalled on your mobile device, you can
check the status of your washer-dryer
from anywhere and start it remotely.
You can also operate your washer-
dryer remotely with the MobileStart
programme.
You can switch off the
setting if you do not want to operate the
washer-dryer with your mobile device.
If is not switched on, the
Remote control
app can still be used to cancel the pro-
gramme.
Use the "Delay start" sensor to set a
time by which you want to start the
washer-dryer and start the delay start
setting is only vis-
setting is set up
Remote control
(see "Delay start/SmartStart").
The washer-dryer will then start within
the specified timeframe when it receives
your signal.
If it has not received a start signal by
the latest start time set, the washer-
dryer will start automatically.
Remote control is switched off in the
factory default setting.

SmartGrid

The SmartGrid setting is only visible if
the
Miele@home
activated.
This function can be used for starting
your washer-dryer automatically at a
time when the energy tariff of your en-
ergy supplier is more economical.
Activating
SmartGrid
start button a new function.
Set the
SmartStart by
start" sensor (see "Delay start/
SmartStart").
The washer-dryer will then start within
the timeframe specified when it receives
a signal from the energy supplier.
If a signal has not been received from
the energy supplier by the latest start
time set, the washer-dryer will start
automatically.
The SmartGrid function is switched off in
the factory default setting.
Settings
setting is set up and
gives the Delay
using the "Delay
119