Appliance Parameters; Copyrights And Licences; Installation Requirements; Low Water Pressure - Miele WTR 860 WPM Operating Instructions Manual

Settings

Appliance parameters

Copyrights and Licences

Miele uses their own and third party
software which is not subject to any so-
called Open Source Licence for the op-
eration and control of the appliance.
This software/these software compon-
ents are protected by copyright. The
copyright powers of Miele and third
parties have to be respected.
Furthermore, this appliance contains
software components which are distrib-
uted under Open Source licence condi-
tions. Please refer to the menu item
|
tings Appliance parameters
|
tion Open source licences
ance for the Open Source components
contained therein, together with the
corresponding copyright notices, cop-
ies of the licencing conditions valid at
the time, and any further information.
The liability and warranty provisions of
the Open Source licence terms and
conditions as stated therein apply only
in relation to the respective rights hold-
ers.
122
Set-
|
Legal informa-
in the appli-

Installation requirements

Low water pressure

If the water pressure is too low, the
washer-dryer will stop the programme
and a water inlet fault message will
appear.
This setting can be activated to ensure
problem-free water intake where the
water pressure is constantly low.
Factory default setting:
sure is switched on.

Suds cooling

Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a Cot-
tons programme with a temperature of
70 °C or higher is selected.
Activate suds cooling:
- To prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or slops basin
- In buildings where the drainage pipes
do not comply with DIN 1986
Factory default setting: suds cooling is
switched off.
Low water pres-