Kenwood CT Series Instruction Manual page 18

18
To pause recording temporarily
Pause
8
PAUSE
÷ The 8 indicator lights.
How to provide non-recorded blanks betw een programs
In stop mode
Press successively tw ice.
¶
REC/ARM
To start recording again from the biginning
The follow ing procedure is useful w hen you w ant to cancel recording in progress and re-start it.
A non-recorded space of about 4 seconds or more should be reserved before the position w here recording w as started.
CT-2050/ KXF-W6010
CT-203/ KXF-W4010
Downloaded from: http://www.usersmanualguide.com/
To resume recording
¶
REC/ARM
During recording
Press once.
¶
REC/ARM
1
Rew ind during recording.
During recording in the 3 direction:
1 ¡
During recording in the 2 direction:
1 ¡
2
Press the REC/ ARM (¶) key tw ice.
¶
REC/ARM
3
Replay the tune you w ish to record.
4
Press the REC/ ARM (¶) key once.
¶
REC/ARM
How to record (CT-203/KXF-W 4010; Deck B only)
To stop recording
1
Stop the tape transport.
CT-2050/ KXF-W6010
CT-203/ KXF-W4010
2
Stop playing the source component.
÷ After leaving a non-recorded blank of about 4 seconds, the deck enters
the record-pause mode.
÷ When the ¡ (or 1 ) key is pressed during recording, recording is
aborted and tape is rew ound as show n below if there is a non-recorded
space of more than 4 seconds before the recording start position.
Tape stops after 2 sec.
of transport.
Recorded tune
Blank of 4 sec. or more.
÷ If there is no recorded tune before, the tape w ill be rew ound then
stopped.
÷ When re-recording from the beginning of tape, feed the leader tape (the
first portion of tape that cannot be recorded) before starting re-
recording.
÷ A non-recorded space of about 4 seconds is reserved on tape, then the
tape transport stops.
÷ Recording starts.
CT-2 0 5 0 / 2 0 3 / KXF-W 6 0 1 0 / W 4 0 1 0 (En/ M )
2 7 3
Re-recording
Tune to be re-recorded.