Sharp AN-LS1 Operation Manual page 48

Check the network settings for the computer and AN-LS1.
\ Check the following network settings for AN-LS1.
\ Take the following steps for checking the network settings for the computer.
• Communication may not be established even after carrying out the network settings for the computer. In
such cases, restart your computer.
Downloaded from: http://www.usersmanualguide.com/
• IP address
\ \
Check that the IP address for AN-LS1 is not duplicated on the network.
• Subnet mask
\ \
When the gateway setting for AN-LS1 is "0.0.0.0" (Not Used), or the gateway setting for AN-
LS1 and the default gateway setting for the computer are the same:
• The subnet masks for AN-LS1 and the computer should be the same.
• The IP address parts shown by the subnet mask for AN-LS1 and the computer should be
the same.
(Example)
When the IP address is "192.168.150.2" and the subnet mask is "255.255.255.0" for AN-
LS1, the IP address for the computer should be "192.168.150.X" (X=3-254) and the subnet
mask should be "255.255.255.0".
• Gateway
\ \
When the gateway setting for AN-LS1 is "0.0.0.0" (Not Used), or the gateway setting for AN-
LS1 and the default gateway setting for the computer are the same:
• The subnets for AN-LS1 and the computer should be the same.
• The IP address parts shown by the subnet mask for AN-LS1 and the computer should be
the same.
(Example)
When the IP address is "192.168.150.2" and the subnet mask is "255.255.255.0" for AN-
LS1, the IP address for the computer should be "192.168.150.X" (X=3-254) and the subnet
mask should be "255.255.255.0".
• The factory default setting of the network setting for AN-LS1
IP address : 192.168.150.2
Subnet mask : 255.255.255.0
Gateway address : 0.0.0.0 (Not Used)
• For network settings for AN-LS1, refer to
1. Open a command prompt (MS-DOS Prompt).
• In the case of Windows 98 or 98SE: click "START" → "Programs" → "MS-DOS Prompt" in
order.
• In the case of Windows Me: click "START" → "Programs" → "Accessories" → "MS-DOS
Prompt" in order.
• In the case of Windows 2000: click "START" → "Programs" → "Accessories" → "Command
Prompt" in order.
• In the case of Windows XP: click "START" → "Programs" → "Accessories" → "Command
Prompt" in order.
2. After launching the command prompt (MS-DOS Prompt) enter a command "ipconfig".
page 18.
48