Connecting Devices; Connecting A Controller Or A Computer; Connecting A Projector - Sharp AN-LS1 Operation Manual

Connecting Devices

Connect a commercially available controller or computer and a projector to AN-LS1.

Connecting a Controller or a Computer

In the case of controlling a projector via RS-232C as well as via the Ethernet LAN, connect a
commercially available controller or computer to the RS-232C (CONTROLLER) terminal.

Connecting a Projector

Connect a projector to the RS-232C (PROJECTOR) terminal.
Downloaded from: http://www.usersmanualguide.com/
RS-232C serial control
cable
(commercially available)
• For connection procedures for each device, please refer to the operation manual for each device.
• Make sure not to connect a controller or a computer to the RS-232C (PROJECTOR) terminal.
• Set as follows for the Port settings for RS-232C.
Baud Rate : Set the same value as AN-LS1.
Data Length : 8 bits
Parity Bit : None
Stop Bit : 1 bit
Flow Control : None
• In the case of connecting to a controller, use a suitable cable for the RS-232C cable.
• In the case of connecting to a computer, use a cross-over type cable for the RS-232C cable.
RS-232C serial control
cable
(commercially available)
• For connection procedures for a projector, please refer to the operation manual for the projector.
• In the case of connecting to a projector, use a cross-over type cable for the RS-232C cable.
RS-232C (CONTROLLER)
To RS-232C terminal
(Page
RS-232C (PROJECTOR)
To RS-232C terminal
9
Controller
(commercially available)
or
Computer
11)
Projector