Setting Up; Preparing The Remote Control; Setting Up The Remote-Controlled Socket - Silvercrest RC DS2 0201-A DE 3726 Operation And Safety Notes

Do not switch the wireless sock-
ets erratically or unattended.

Setting up

Q
Preparing the re-
Q
mote control (fig. A)
1. Open the battery compartment
on the back of the remote con-
trol by turning the battery cover
to the left with a coin or a
screwdriver. Insert the button
cell. Ensure correct polarity
(+ = up).
2. Press one of the ON/OFF
buttons or
2
remote control is working; if so,
the operating control lamp
will light up.
to verify the
3
1
Safety / Setting up
Setting up the remote-
Q
controlled socket
(fig. B)
1. Plug the wireless socket into an
earthed mains socket. You now
have 30 seconds to complete
steps 2 and 3.
note: Always plug in the
wireless socket in the direction
indicated on the product label
to maintain the splash water pro-
tection (arrow must point up).
2. Point the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
3. Push the respective ON button
of the Channel ON/OFF but-
ton (A, B, C or D) on the
2
remote control. You can now
remotely switch a connected
device on or off. Once assigned
the process will complete.
GB 25