Loading Paper - Sharp MX-M232D Operation Manual

LOADING PAPER

Make sure that the machine is not copying or printing, and then follow these steps to load paper.
Loading the paper tray
1
Gently lift and pull out the paper tray
until it stops.
2
Adjust the plates in the tray to the
length and width of the paper.
• The plate A is a slide-type
Plate B
guide. Grasp the locking knob
on the guide and slide the
guide to the indicator line of
the paper to be loaded.
Plate A
• The plate B is an insert-type
guide. Remove it and then
insert it at the indicator line of
the paper to be loaded.
• When using 11" x 17" sized
paper store the plate B in the
slot at the left front of the
paper tray.
3
Push the pressure plate down.
Push the centre of the pressure
plate down until it locks into
place.
For how to load paper, refer to the steps below.
BEFORE USING THE MACHINE
4
Load paper into the tray.
• Do not load paper higher than the line on
Note
the tray (up to 250 sheets).
• Do not add paper to the loaded paper. It
may cause multiple feed of paper.
• A5 (5-1/2" x 8-1/2") can be used in the
upper paper tray but cannot be used in
other trays (including trays in optional paper
feeding unit).
5
Gently push the paper tray into the
machine.
• If you loaded a different size of paper than
Note
was loaded previously in the tray, go to
"CHANGING THE PAPER SIZE SETTING
OF A TRAY" (p.26).
• When misfeed occurs, rotate the paper 180
degrees and reload it.
• Straighten curled paper before using it.
• Open the package of
the paper and load it
without fanning the
paper.
• Make sure the stack of
paper is straight before
loading it.
24
2