Using The Bypass Tray To Copy Aspecial Size Original - Sharp MX-M232D Operation Manual

USING THE BYPASS TRAY TO COPY A SPECIAL SIZE ORIGINAL
When the bypass tray is being used for copying and an original that is placed on the document glass is detected as
being a special size, the display will prompt the user to set the original size. To make a copy in this type of situation,
follow the steps below.
1
Load paper in the bypass tray and place
the original on the document glass.
2
Touch the [PAPER SELECT] key and
then select the bypass tray.
RE PAPER SELECT COPY RATIO AUTO IMAGE
ODE RESOLUTION ADDRESS FORMAT O
AM RESOLUTION ADDRESS BROADCAST O
A message will appear asking you whether you wish to
set the original size or make the copy without setting it.
To make a copy without setting the original size, press the
[START] key ( ). To set the original size, go to step 3.
If you load thick paper in the bypass tray,
Note
press the [PAPER] key until "EXTRA" is
highlighted. The paper type is set to thick
paper. The setting is cleared when "Auto
clear" works or the [CA] key is pressed.
For restrictions on paper types and weights,
see "PAPER" (p.23).
[OK]:ORIG. SIZE
ENTER
100%
EXTRA
3
Press the [OK] key.
GHI
BACK
OK
PQRS
PY
AN
The original size selection screen appears with "SIZE
INPUT" selected.
4
Select AB or inches with the [ ] or
[ ] key, and then select the original
size with the [ ] or [ ] key.
PQ
ED COPY
LEX SCAN
LEX SCAN
ACC
[OK]:ORIG. SIZE
ENTER
AUTO
100%
EXTRA
AUTO
ORIG. SIZE ENTER
AB
A4R
A5
SIZE INPUT
5
Press the [OK] key.
If "SIZE INPUT" was selected in step 4:
OK
The size entry screen appears and is ready for entry of
the width of the original.
If you selected inches in step 4, the screen will
Note
be ready for you to enter the width in inches.
If other than "SIZE INPUT" was selected in step 4:
You will return to the base screen. Go to step 8.
6
Select "X" (width) with the [ ] or [ ] key
and enter the width with the [ ] or [ ] key,
and then do the same for the length (Y).
• Any number from 64 mm to 432 mm (2-1/2"
Note
to 17") can be entered for the width, and
any number from 64 mm to 297 mm (2-1/2"
to 11-5/8") can be entered for the length.
• The entered size is retained until the
power is turned off, even if "SIZE INPUT"
is selected again and the entry screen of
step 5 is displayed.
7
Press the [OK] key.
You will return to the base
OK
screen.
8
Press the [START] key (
MNO
Copying begins.
WXYZ
@.-_
AD-END
COPY FUNCTIONS
SIZE INPUT
SIZE(mm)
X: 210
Y: 148
SIZE INPUT
SIZE (mm)
X: 100
Y: 100
).
36
3