Toro Greensmaster TriFlex 3420 Operator's Manual page 19

1. Traction pedal—forward
2. Traction pedal—reverse
Figure 12
Ground speeds are as follows:
•
3.2 to 8 km/h (2 to 5 mph) forward mowing speed
•
16 km/h (10 mph) maximum transport speed
•
4.0 km/h (2.5 mph) reverse speed
Steering-Arm-Locking Pedal
Press the pedal (Figure
steering arm for operator comfort, then, release the
pedal to lock the arm in place.
Throttle Lever
The throttle lever (Figure
speed of the engine. Move the throttle lever toward
the F position to increases the engine speed;
AST
move it toward the S
LOW
engine speed.
Note:
You cannot shut off the engine using the
throttle lever.
Figure 11
3. Steering arm locking pedal
11) and raise or lower the
13) allows you to control the
position to decrease the
g014603
1. Ignition switch
2. Functional-control lever
3. Raise/Lower mow control
Raise/Lower Mow Control
Moving the control
operation lowers the cutting units and starts the reels.
Pull back on the control to stop the reels and raise
the cutting units. During operation the reels can be
stopped by pulling back on the control momentarily
and releasing it. Start the reels by moving the control
forward.
Functional Control Lever
g005105
The functional control lever
traction selections plus a N
permissible to shift from mow to transport or transport
to mow (not to neutral) while the machine is in motion.
No damage will result.
•
R Position—neutral and backlapping
EAR
•
M Position—used for mowing operation
IDDLE
•
F Position—used for transport operation
RONT
Ignition Switch
Insert the key into the switch
clockwise as far as possible to the S
to start the engine. Release the key as soon as the
engine starts; the key will move to the O
Turn the key counterclockwise to the O
stop the engine.
Parking-Brake Lever
Pull up on the brake lever
parking brake. Disengage it by squeezing the release
lever on the underside of the brake lever and lowering
19
Figure 13
4. Throttle lever
5. InfoCenter
(Figure 13) forward during
(Figure 13) provides 2
position. It is
EUTRAL
(Figure 13) and turn it
TART
N
position to
FF
(Figure 14) to set the
g033079
position
position.