Toro Greensmaster TriFlex 3420 Operator's Manual page 32

Installing the Electrical
Counterweights
Secure the electrical counterweight to the existing
counterweight with 2 capscrews as shown in
29.
Figure 29
1. Cap screw (2)
2. Electrical counterweight
Installing the Cutting Units
1. Disconnect the cutting unit power disconnect
couplers; refer to
Connectors (page
CAUTION
If you do not disconnect the power
to the cutting units, someone could
accidentally start the cutting unit,
causing serious injury to hands and feet.
Always separate the cutting unit power
disconnect couplers before working on
the cutting units.
2. Lift up on the foot rest and swing it open, allowing
access to the center cutting unit position
30).
CAUTION
The footrest can pinch fingers if it falls
into the closed position.
Keep your fingers clear of the area where
the footrest seats while it is open.
Figure
3. Existing counterweight
Cutting Unit Power Disconnect
24).
1. Footrest—closed
3. Position the cutting unit under the center
suspension arm.
4. With the latches on the suspension-arm bar
pointing up (i.e., open)
suspension arm down so that the bar fits over
the bar across the top of the cutting unit
32).
g036342
1. Latch—closed position
2. Suspension-arm bar
(Figure
1. Suspension-arm bar
32
Figure 30
2. Footrest—open
(Figure 31), push the
Figure 31
3. Latch—open position
Figure 32
2. Cutting-unit bar
g014602
(Figure
g014609
g036343