Installing The Roll Bar; Installing The Seat - Toro Greensmaster TriFlex 3420 Operator's Manual

Description
Pre-delivery Inspection Sheet
Noise rating certificate
Certificate of compliance
Ignition keys
1

Installing the Roll Bar

Parts needed for this procedure:
1 Roll bar
4 Bolt (1/2 x 3-3/4 inches)
4 Flange-nut (1/2 inch)
Procedure
1. Remove the top crate support from the crate.
2. Remove the roll bar from the crate.
3. Install the roll bar into the pockets on each side
of the machine, using 4 bolts (1/2 x 3-3/4 inches)
and 4 flange-nuts (1/2 inch) as shown in
3.
1. Roll bar
2. Bolt (1/2 x 3-3/4 inches)
4. Torque the fasteners to 136 to 149 N∙m (100 to
110 ft-lb).
Figure 3
3. Flange-nut (1/2 inch)
Qty.
1
1 Save for future reference
1
2 Start the engine.
2

Installing the Seat

Parts needed for this procedure:
1 Seat
1 Seat wire harness
Procedure
Note:
Mount the seat in the front set of mounting
holes to gain an additional 7.6 cm (3 inches) in the
forward adjustment, or in the rear mounting holes
for an additional 7.6 cm (3 inches) in the rearward
adjustment.
Figure
1. Remove and discard the lag bolts securing the
seat slides and cut the shipping straps.
2. Remove the 4 bolts (5/16 x 3/4 inch) and
washers from the shipping bracket and discard
the bracket.
3. Secure the seat to the seat base with 4 bolts
and washers removed previously
g014601
13
Use
(Figure 4).