Installing The Roll Bar - Toro Greensmaster 3420 TriFlex Operator's Manual

Media and Additional Parts
Description
Operator's Manual
Engine owner's manual
Declaration of Conformity
Noise rating certificate
Ignition keys
1

Installing the Roll Bar

Parts needed for this procedure:
1 Roll bar
4 Bolt (1/2 x 3-3/4 inches)
4 Flange nut (1/2 inch)
Procedure
1. Remove the top crate support from the crate.
2. Remove the roll bar from the crate.
3. Remove the 3 bolts that secure the right side
cover to the machine and remove the side cover.
4. Remove the 2 bolts that secure the fuse-block
bracket to the ROPS bracket as shown in
3.
Qty.
1 Review the manual before operating the machine.
1 Use the manual to reference engine information.
1
For CE compliance
1
2 Start the engine.
Figure
1. Roll bar
2. Right side cover
3. Fuse block bracket
5. Align the fuse-block bracket on the right ROPS
bracket and use 4 bolts (1/2 x 3-3/4 inches) and
4 flange nuts (1/2 inch) to install the roll bar into
the ROPS brackets on each side of the machine.
6. Torque the fasteners to 136 to 149 N∙m (100 to
110 ft-lb).
7. Use the 3 bolts that you previously removed to
secure the right side cover to the machine.
11
Use
Figure 3
4. Bolt (1/2 x 3-3/4 inches)
5. Right ROPS bracket
6. Flange nut (1/2 inch)
g233711