Driving The Machine Without Mowing; Mowing The Green - Toro Greensmaster 3420 TriFlex Operator's Manual

2. Move the functional-control lever to the M
position or the T
RANSPORT
start the engine.
The engine should not turnover or start, which
indicates that the interlock system is operating
correctly. Correct the problem if it is not
operating properly.
3. Sit on the seat, move the traction pedal to the
N position, move the functional-control
EUTRAL
lever to the N
EUTRAL
parking brake.
4. Start the engine and move the functional-control
lever to the M
OW
position.
The engine should shut off, which indicates that
the interlock system is operating correctly.
Correct the problem if it is not operating properly.
Checking the Operator's Presence
Switch
1. Sit on the seat, move the traction pedal to the
N position, move the functional control
EUTRAL
lever to the N
EUTRAL
parking brake.
2. Start the engine.
3. Release the parking brake, move the functional
control lever to the M
the seat.
The engine should shut off, which indicates
that the interlock system is operating correctly.
Correct the problem if it is not operating properly.
Checking the Raise/Lower Mow
Control
1. Sit on the seat, move the traction pedal to the
N position, move the functional control
EUTRAL
lever to the N
EUTRAL
parking brake.
2. Start the engine.
3. Move the raise/lower mow control forward to
lower the cutting units. The cutting units should
lower but not start rotating.
If they start rotating, the interlock system is not
operating correctly; correct the problem before
operating the machine.
position and try to
position, and engage the
position or the T
RANSPORT
position, and engage the
position, and rise from
OW
position, and engage the
Driving the Machine without
OW
Mowing
•
Ensure that the cutting units are fully raised.
•
Move the functional-control lever to the T
position.
•
Use the brakes to slow the machine while going
down steep hills to avoid loss of control.
•
Always approach rough areas at a reduced speed
and cross severe undulations carefully.
•
Familiarize yourself with the width of the machine.
Do not attempt to pass between objects that are
close together to prevent costly damage and
downtime.

Mowing the Green

Important:
on your model) sounds or you notice an oil leak
while cutting on a green, immediately raise the
cutting units, drive directly off the green, and
stop the machine in an area away from the green.
Determine the cause of the leak and correct the
problem.
Before mowing greens, find a clear area and practice
performing basic machine functions (e.g., starting and
stopping the machine, raising and lowering the cutting
units, and turning).
Inspect the green for debris, remove the flag from
the cup, and determine the best direction to mow.
Base the direction to mow on the previous mowing
direction. Always mow in an alternate pattern from the
previous mowing so that the grass blades are less apt
to lay down and therefore be difficult to trap between
the reel blades and the bedknife.
Cutting the Green
1. Approach the green with the functional-control
lever in the M
speed.
2. Start on 1 edge of the green so that you can use
the ribbon procedure of cutting.
Note:
leaves a neat, attractive pattern on the greens.
3. Push forward the raise/lower mow lever as the
front edges of the grass baskets cross the outer
edge of the green.
Note:
the turf and starts the reels.
Important:
and raises slightly after the front cutting
units do; therefore, you should practice
29
If the leak detector alarm (if equipped
position and the throttle at full
OW
This holds compaction to a minimum and
This procedure drops the cutting units to
The center cutting unit drops
RANSPORT