Advertisement
Programming the timer
This VCR incorporates two programming procedures for timer recording.
One is conventional, whereby the TV programme No., start time, stop time, recording date, etc., must be input,
and the other is called VIDEO Plus+ whereby up to 9 digits must be input.
¢
Programmingthe timer using VIDEO Plus+ programming system
Things to know before starting programming
¢
Turn the VCR and TV on, then setthe TV to the
video programme number.
* While you are programming the timer, the display
on the TV screen will prompt you through the
procedure.
Controls
TV Screen
¢ To find the PlusCode number, look in the TV
section of most newspapers or TV guide
magazines.
* Check that the time and date are correct.
Turn the VCR and TV on,then set the TV to the
video programme number.
VIDEO Plus+
O-@
0000
Sits amea ceeiig
WENTER THE PLUSCODE
OseRUSS RWLe
Press the VIDEO Plus+ button.
The VIDEO PLUS PROGRAMME display appears on
the TV screen.
Notes:
¢
Ifthe clock has not been set, the CLOCK SET
display will appear.
¢ Ifthe VIDEO Plus+ button is pressed when all the
programme numbersthat the VCR can store are
occupied, a "FULL" indication will appear in the
VCR's display and on the TV screen.
When the memoryis full, and you wish to input
further programmes, you must delete unwanted
programmesfrom the VCR's memory.
Press the @) button when the programme
information you wantto clear is displayed. Refer to
page 36 for further information.
ase Reec
WENTER THE PLUSCODE
123
WUEOASa moa
Enter the PlusCode numberfrom the TV guide or
newspaper etc. for the programme you wantto
record, by using the number buttons.
30
aia
OR CRS aera nL)
ERLE
De eAeg
RROe As
is
Covo6 Sah ciceem
cursor
cal cao
(Ps
8 19:30 > 20:00
eR 3
NEL Caismeg
00 oe esea
After entering the PlusCode number, press the
VIDEO Plus+ button.
The programmed details appear.
Note: If you have entered a non-existing number,
"ERROR"will appear on the TV screen.
If you wish to change the programme allocations, the
start time or end time, press the 0000 button to
display the cursor "Ml". Press the 0000 button
repeatedly until the cursor reaches the digit you want
to change, then enter the programme number,start
time or end time.
Advertisement
