Top Panel - Hitachi EC702HP Operation Manual

Section 3 - Installation (ATSC EC702HP Transmitter)

3.5.5 Top Panel

Figure 3-16
Top panel with identifications
Description:
The following connectors are located in the top panel:
1,3- RF AFTER FILTER IN A / RF AFTER FILTER IN B
 Function: Measurement point of the signal after the filter
 Type: N Female
2- GPRS ANTENNA IN
 Function: Antenna input for the GPRS module
 Type: SMA Female
Manual Rev. 0.0 - April 2016
20
5 8 11 13 16 19
3
2
10 15 18
7
1
4 6 9 12 14 17
6,8- GPS ANTENNA IN A / GPS ANTENNA IN B
 Function: Antenna input for the GPS module
 Type: SMA Female
7- CONTROL PORT
 Function: Equipament Managment
 Type: RJ45
9,11- ASI / 310M IN 1A / ASI / 310M IN 1B
 Function: Transport Stream input
 Type: BNC Female
 Impedance: 75 Ohms
10,15 - ETHERNET* STREAMING A / ETHERNET
STREAMING B
 Function:Transport Stream over IP Interface
 Type: RJ45
12,13- ASI / 310M IN 2A / ASI / 310M IN 2B
 Function: Transport Stream input
 Type: BNC Female
 Impedance: 75 Ohms
14,16- ASI OUT A / ASI OUT B
 Function: Sample ASI signal modulator
 Type: BNC Female
 Impedance: 75 Ohms
18- 10MHz REF. OUT
 Function: Reference output 10MHz
 Type: BNC Female
17,19- 10MHz REF. IN A / 10MHz REF. IN B
 Function: Reference output 10MHz
 Type: BNC Female
20- RF OUT
 Function: Transmitter RF output before filter
NOTE:
The other connectors identified are not used on this
equipment.
*Ethernet is a trademark of the Xerox Corporation.
3-18