Table of Contents
Advertisement
Section 3 - Installation (ATSC EC702HP Transmitter)
3.8
ON SITE PHYSICAL ASSEMBLY
NOTE: trained personnel ONLY should conduct the on-site physical assembly.
The air intake (front) and air outlet (back) should be completely clear.
3.8.1
1- Unpacking the transmitter and drawers.
2- Position the rack where the equipment is installed in compliance with the following issues:
Antenna cable
AC Power Supply
RF Cable
Transport Stream (ASI) cables
Grounding point
Remark: The transmitter rack must be positioned in such a way so as to ensure easy access
from any side. The gap between the transmitter and the shelter walls must be minimum 1.5
meter.
Visual inspection:
a. Remove the lateral and rear panel of the transmitter and proceed to a visual inspection
searching for any alteration that may have happened during the transportation of the equipment.
b. Pay special attention on the RF and signal cable connectors, ie. loose screws.
c. Check the power switches located on the left of the rear panel of the units, make sure they are
in the "ON" position.
Grounding:
For personal and equipment safety reasons, connect the ground of the of the transmitter room
to the ground of equipment before proceeding to the next steps.
Manual Rev. 0.0 - April 2016
Assembly Instructions
Figure: 3-43
AC Grounding
Site Grounding
3-33
Advertisement
Table of Contents
