Hitachi EC702HP Operation Manual page 72

Section 3 - Installation (ATSC EC702HP Transmitter)
B- AC power cables and exciter's grounding
 Connect the AC feeding pigtail to the identified 3-pin connector located in the left side of the
each Digital Exciter drawer's rear panel.

Connect the grounding mesh in the GND screw on the rear panel of each digital exciter.
GND: Ground - Connect this terminal to ground at the installation site.
Manual Rev. 0.0 - April 2016
AC Input cable, ON/OFF switch and fusible - Module 40153
SCREW GROUNDING
Screw grounding - Digital Exciters
Figure 3-49
Figure 3-50
EXCITER A
EXCITER B
EXCITER A
EXCITER B
3-37