Hitachi EC702HP Operation Manual page 76

Section 3 - Installation (ATSC EC702HP Transmitter)
The infomation of the connections below refer only to equipments which have optional GPS
and GPRS modules.
D- GPS Module Cables (Optional)
 Position the GPS antenna next to a window, for example.
 Connect the antenna in the input GPS ANTENNA IN of the rack top panel.
 Make the connection between the input GPS ANT. of the digital exciter to respective connector of
the panel located at the top of the rack.
E- GPRS Module Cables (Optional)
 Connect the drawer DC pigtail.
F- AC Unit Cables
Connect the cables on the back of MCCB module. Note identification in cables and photo below.
The cable connectors INTERLOCK and OUTPUT 1 - PA does not have identification.
INTERLOCK CABLE
WITHOUT IDENTIFICATION
CABLE A
For more information about AC Unit, see Annex -- MOD GV 4993_40030_40031_40061_40062.
Manual Rev. 0.0 - April 2016
GPRS UNIT
CABLE B
AC Unit Connections - Module 40062
DC PIGTAIL
DC PIGTAIL
DC pigtail - GPRS Unit
(MOD GV 40072)
OUTPUT 2 CABLE
OUTPUT 3 CABLE
Figure 3-55
Figure 3-54
OUTPUT 1
CABLES – PA
WITHOUT
IDENTIFICATION
3-41