Honeywell ScanPal EDA71 User Manual page 45

Scan Barcodes
By default, the tablet imager is enabled for scanning. It supports
omni-directional (360°) barcode scanning and an aiming beam is provided to help
assist with targeting barcodes.
Before you start scanning barcodes, go into Settings > Honeywell Settings >
Scanning > Internal Scanner and modify the scan profile to enable only the
barcode symbologies that you need. By reducing the active symbology list, you can
increase scan speed.
1. Point the scanner window at the barcode. For optimum performance, avoid
2. Press and hold any Scan button.
3. Center the aiming beam over the barcode. Make sure the entire barcode is
4. Release the Scan button when the tablet beeps, and the Scan Status LED
Note: Not all barcode symbologies are enabled by default. If a barcode does not scan, the
correct symbology may not be enabled.
About Scanning Configuration Barcodes
After completing the out-of-box set up process, Provisioning mode is
automatically turned Off. Scanning a barcode to install applications, certificates,
configuration files, and licenses on the tablet is restricted unless you enable
Provisioning mode in the Settings app.
EDA71 User Guide
The digital scan button appears on the screen when you open any of the apps
you selected during the button setup. Tap and hold the button to activate the
imager and scan a barcode.
reflections by scanning the barcode at a slight angle.
inside of the illumination frame.
briefly turns on. The barcode information is entered into the application in use.
35