Honeywell ScanPal EDA71 User Manual page 71

4. Tap the name of the certificate to you want to disable or remove. The Security
5. Scroll to the bottom of the screen and tap Disable (for System certificates) or
6. Tap OK.
Note: You can enable a disabled System certificate but if you remove a User certificate, you
must install it again to enable it.
About Bluetooth Communications
Your tablet is equipped to communicate with other devices using Bluetooth
technology. The Bluetooth radio must be turned On to discover, pair and connect to
other Bluetooth devices. System bar icons indicate Bluetooth radio status.
Connect a Bluetooth Device
To connect to a Bluetooth device, you must turn On the Bluetooth radio and then
select the device from a list of discovered devices.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings
3. If necessary, tap Off
4. Tap Pair a new device.
5. Select a device on the list to initiate a pairing request.
6. When the pairing request message appears:
7. (Optional) Once paired to a device, you can connect manually to the device. Tap
EDA71 User Guide
The trusted credentials screen has two tabs:
• System shows Certificate Authorities (CA) certificates permanently installed
on the tablet. They can only be disabled.
• User shows CA certificates you have installed yourself. You can remove these
certificates.
certificate screen appears.
Remove (for User certificates).
> Connected devices > Bluetooth.
Bluetooth devices appears.
A list of available Bluetooth devices in range appears.
• Verify the pairing PIN is the same on both device, and then tap Pair.
OR
• If the pairing request requires a PIN, enter the PIN, and then tap Pair.
When the device is successfully paired with the tablet, the device name appears
under Paired devices.
the device under Paired devices. The word "Connected" appears under the
to toggle the Bluetooth radio On . A list of available
61