Siemens SINAMICS S120 Function Manual page 41

Password
The safety password protects the safety parameters against unintentional or unauthorized
access.
In commissioning mode for Safety Integrated (p0010 = 95), you cannot change safety
parameters until you have entered the valid safety password in p9761 for the drives or
p10061 for the TM54F.
● When Safety Integrated is commissioned for the first time, the following applies:
● In the case of a series commissioning of Safety or in the case of spare part installation,
● Change password for the drives
● Change password for the TM54F
If you need to change safety parameters but you do not know the safety password, proceed
as follows:
1. Set the entire drive unit (Control Unit with all connected drives/components) to the factory
2. Recommission the drive unit and drives.
3. Recommission Safety Integrated.
Or contact your regional Siemens office and ask for the password to be deleted (complete
drive project must be made available).
Safety Integrated
Function Manual, (FHS), 11/2009, 6SL3097-4AR00-0BP0
– Safety passwords = 0
– Default setting for p10061 = 0
– Default setting for p9761 = 0
In other words:
The safety password does not need to be set during first commissioning.
the following applies:
– The safety password is retained on the memory card and in the STARTER project.
– No safety password is required in the case of spare part installation.
– p0010 = 95 Commissioning mode
– p9761 = Enter "old safety password".
– p9762 = Enter "new password".
– p9763 = Confirm "new password".
– The new and confirmed safety password is valid immediately.
– p0010 = 95 Commissioning mode
– p10061 = Enter "Old TM54F Safety Password" (factory setting "0")
– p10062 = Enter "new password"
– p10063 = Acknowledge "new password"
– The new and acknowledged safety password is valid immediately.
setting.
General information about SINAMICS Safety Integrated
2.4 Parameter, checksum, version, password
41