Mitsubishi Electric MELFA CR750 Series Instruction Manual page 58

5 Parameters
Parameter
Parameter
name
SFPFCSIG CRC of parameter file output
（ valid only in the "Version
Combination B"）
5-46 Safety monitoring function parameters
Description
Start address and end address of the dedicated signal for the
output of CRC of parameter file for the Safety Monitoring
Function is specified.
・Output signal width is fixed to 16bits.
・When the start address is specified, the end address is set
automatically.
・If this function needs to be disabled, set "-1" to the starting
address. (Then, the end address is set to "-1" automatically)
Setting range: -1,0 to 19999
※ For the CRC output of parameter file, refer to "5.1.3 CRC
output of parameter file".
Factory default setting
Start：-1
End：-1