Adjustments; Adjustments; Adjust Throttle Cable - Toro Reelmaster 5500-D Service Manual

Adjustments

Adjust Throttle Cable

1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Position throttle lever forward so it stops against the
seat base slot.
3. At the fuel injection pump, loosen throttle cable con-
nector on the control lever arm.
Note: Do not over tighten the cable connector. The
connector must be free to swivel.
4. Hold fuel injection pump lever arm against the high
idle stop screw and tighten the cable connector.
5. Torque lock nut used to set the friction device on the
throttle lever from 40 to 55 in-lb (4.5 to 6.2 N-m) The
maximum force required to operate the throttle lever
should be 20 lb (89 N).
Kubota Diesel Engine
2
1. Control panel
2
1. Throttle cable connector
2. Control lever arm
Page 3 - 6
1
Figure 4
2. Throttle lever
3
1
Figure 5
3. High idle stop screw
4. Fuel injection pump
Reelmaster 5500-D
4