Transmission Control Linkage - Toro Reelmaster 5500-D Service Manual

Transmission Control Linkage

27
2
1
24
3
23
8
1. Cotter pin
2. Flat washer
3. Cap screw
4. Screw
5. Neutral switch
6. Switch plate
7. Extension spring
8. Lock nut
9. Cap screw
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Disconnect both wires from neutral switch.
CAUTION
The extension spring is under tension. Loosen
lock nut from eye bolt to relieve spring tension.
3. Remove eyebolt from the spring anchor plate and
extension spring from the switch arm (Fig. 33).
4. Remove cotter pin and washer to disconnect traction
control rod from pump control.
5. Loosen cap screw and lock nut securing pump con-
trol to swashplate control shaft.
Reelmaster 5500-D
4
9
10
5
11
6
7
8
21
20
22
25
26
8
Figure 33
10. Ball bearing
11. Spacer
12. Cap screw
13. Traction plate
14. Spring anchor plate
15. Lock washer
16. Cap screw
17. Flanged bushing
18. Grease fitting
Page 4 - 47
19
11
10
8
12
13
17
17
18
20
15
16
14
19. Switch arm
20. Thrust washer
21. Traction stud
22. Hex nut
23. Pump control
24. Rubber bushing
25. Eyebolt
26. Hex nut
27. Traction control rod
Note: It is not necessary to disassemble transmission
control assembly further.
6. Remove four cap screws securing traction plate to
transmission housing. Remove transmission control as-
sembly from transmission.
Installation
1. Position traction plate to the transmission. Secure
traction plate to transmission housing with four cap
screws.
2. Secure pump control to swash plate control shaft
with cap screw and lock nut.
3. Reconnect traction control rod to pump control with
washer and cotter pin.
4. Reinstall eyebolt and extension spring. Connect
both wires to the neutral switch.
5. Adjust traction control neutral (see Adjust Traction
Drive for Neutral).
Hydraulic System (Rev. C)