Specifications; Special Tools - Toro Reelmaster 5500-D Service Manual

Specifications

Item
Front wheel lug nut torque
Rear wheel lug nut torque
Steering cylinder bolt torque
Rear wheel toe-in
Tire pressure (front and rear)
Brake pedal free travel

Special Tools

Order these tools from your Toro Distributor.
Hydraulic Tester (Pressure and Flow) - TOR214678
This tester requires O-ring face seal (ORFS) adapter fit-
tings for use on this machine.
1. INLET HOSE: Hose connected from the system cir-
cuit to the inlet side of the hydraulic tester.
2. LOAD VALVE: A simulated working load is created
in the circuit by turning the valve to restrict flow.
3. LOW PRESSURE GAUGE: Low range gauge to pro-
vide accurate reading at low pressure, 0 to 1000 PSI.
A protector valve cuts out when pressure is about to
exceed the normal range for the gauge. The cutout
pressure is adjustable.
Steering and Brakes
Figure 6
4. HIGH PRESSURE GAUGE: High range gauge
which accommodates pressures beyond the capacity of
the low pressure gauge, 0 to 5,000 PSI.
5. FLOW METER: This meter measures actual oil flow
in the operating circuit with a gauge rated at 15 GPM.
6. OUTLET HOSE: A hose from the outlet side of the
hydraulic tester connects to the hydraulic system circuit.
Page 7 - 4
Rev. D
Specification
45 to 55 ft-lbs (61 to 75 Nm)
30 to 35 ft-lbs. (41 to 47 Nm)
130 to 150 ft-lbs. (176 to 203 Nm)
0.000 to 0.125 in. (0.0 to 3.0 mm)
10 to 15 psi. (0.69 to 1.03 Bar)
0.5 to 1.0 in. (6.0 to 25.0 mm)
Reelmaster 5500-D