Section 3 - Installation; Introduction; Unpacking And Inspection - ABB AV1 Operating Instructions Manual

INTRODUCTION

WARNING

UNPACKING AND INSPECTION

SECTION 3 - INSTALLATION

Several applications are possible using a Type AV positioner. The
steps for installing a Type AV positioner are in sequence in this
section. After installation is complete, refer to
tion information.
Unpack and inspect the equipment.
•
Mount the positioner.
•
Connect tubing to the positioner.
•
Connect wiring to the positioner.
•
NOTES:
1. For application in a hazardous location, refer to ABB Prod-
uct Application Guide, Installing a Type AV Positioner in a
Hazardous Location.
2. Appendix B provides a quick start guide for the Type AV
positioner. It is intended for control engineers having extensive
experience in the use and application of pneumatic positioners.
The quick start guide highlights the major points of installation
and calibration. Detailed installation and calibration information
is contained in this section and in
Select an installation method that provides a fail safe mode
upon loss of controller signal. Certain installation methods
do not stroke the equipment to a fail safe condition upon
loss of controller signal. Failure to select a fail safe installa-
tion method could cause injury to personnel and damage to
equipment.
1. Check for obvious damage to the shipping carton.
2. Open the carton and remove all loose packing.
3. Carefully remove the positioner from the carton and inspect for
any physical damage that may have occurred during shipping.
4. Remove the two cover screws and the positioner cover and
examine the interior for any loose components such as nuts,
screws, springs, etc. Check the data on the nameplate to be cer-
tain the positioner type ordered for the application was received.
Section 4 for calibra-
Section 4.
INTRODUCTION
3 - 1