Connecting The Digital Outputs - Siemens SITRANS DA400 Operating Instructions Manual

Notice
Explosion protection
The use of shielded conduits for the sensor is absolutely necessary.
As a matter of safety, shields should be two-sided, and the sensors should be connected to
the potential balance of the external area.
See also
Terminal assignment (Page 5-3)
Cable gland (Page 5-3)
Connect the ground (Page 5-10)
5.5

Connecting the digital outputs

Procedure
In order to enable the digital outputs, proceed as follows:
1. For up to six digital outputs, it is recommended that you use a 12-wire cable, which is fed
2. Connect the signal conduit according to the following table.
Digital signal
Notice
Explosion protection
Use only approved safe connector hardeners in conformity with DIN 19234, as described in
the chapter "Technical data."
See also
Terminal assignment (Page 5-3)
Cable gland (Page 5-3)
Connect the ground (Page 5-10)
Technical data for the device (Page 9-1)
SITRANS DA400 with protection against explosion
Operating Instructions, 02/2006, A5E00684661-01
through a cable gland (1).
DO 1
+ 31
- 32
DO 2 DO 3
41 51
42 52
5.5 Connecting the digital outputs
DO 4 DO 5
61 71
62 72
Connecting
DO 6
81
82
5-5