Table of Contents
Advertisement
Once set, Utility will request for the Device Password when you try to click on
either, Setup Wizard, Launch Mimic or IP Configuration button.
To remove the password,
a. Select the ASUS Mimic unit from the Utility list.
b. Click IP Configuration.
c. Enter the unit's Device Password
d. Go to Advanced
e. Click OK to confirm.
NOTE:
If the password is lost, you must use the Master Password to reset the Password
field
ii.
Management Protocol
This setting allows the administrator to determine the LAN HTTP access (web)
to ASUS Mimic IP camera. For added security, the administrator can choose to
use either the default open port 80 or other ports (between 1 to 65534).
Once the HTTP port number is set to another port (other than 80), the full LAN
IP address must be entered in order to access the ASUS Mimic web interface.
Example:
If a value of say, 8080 is set as the HTTP port number, then enter
http://192.168.0.177:8080 in order to access ASUS Mimic web interface.
Uncheck to disable this function.
2.4 Upgrade Firmware
Click this to bring up the upgrade firmware dialog box.
To check the internet for the latest firmware, click Next
Otherwise, check Upgrade the firmware with file saved on the local hard drive.
Click Browse to choose the location where the *.bin file is located.
2.5 About
ASUS Mimic - user manual
Device Password and delete both the entries.
Chapter 5: Using the Utility Program
-47-
Advertisement
Table of Contents
