Assembly; Safety Information For Installation; Mounting The Device - Siemens SITRANS DA400 Operating Instructions Manual

Assembly

4.1

Safety information for installation

Ambient temperature
Fire hazard
Fire hazard resulting from hot surfaces. When installing the sensor, take note of the surface
temperature of the installation site.
Overview
The SITRANS DA400 and the sensor are mounted in different ways. In general:
Note
Protection against harmful outside influences
To protect the SITRANS DA400 against harmful outside influences, a housing should be
fitted. Harmful external influences can occur if you install the SITRANS DA in the open air,
where it can be influenced by intensive frost, heat or rain.
4.2

Mounting the device

Condition
To mount the device, you need three screws with a diameter of 6 mm. These are not
supplied with the device.
Mounting the device
1. Screw the three screws through the mounting holes to mount the device. The position of
SITRANS DA400 for material flow monitoring with protection against explosion
Operating Instructions, 09/2007, A5E00841152-01
WARNING
the mounting holes and the mounting dimensions in millimeters are indicated on the rear
of the housing.
4
19