Philips OccuSwitch DALI LRM2070 User Manual page 32

OccuSwitch DALI
User Guide
Page 32
Manual calibration with the push button and current
light level
The following tools are required for this method:
• IR remote control unit .
• Stepladder for operating the service button .
1 Change the light level to the correct light value, using
the IR remote control .
2 Press the push button on the OccuSwitch DALI for at
least 3 seconds .
The LED blinks in a cycle of "long yellow - short green"
to indicate that calibration is about to start .
3 For a more reliable calibration, get out of the sensor's
measuring area now .
After 10 seconds the OccuSwitch DALI takes the current
light sensor value as new set point .
The LED stops its visual indication and the luminaires
flash once indicating that calibration is completed .
C Caution
When the OccuSwitch DALI is calibrated manually with
the push button and using an IR control, the offset can
be different from an automated mode .
Automatic calibration with the push button and installed
light level
The following tools are required for this method:
• IR remote control unit
• Stepladder for operating the service button .
1 Press the push button on the OccuSwitch DALI for at
least 3 seconds .
The LED blinks in a cycle of "long yellow – short green"
to indicate that calibration is about to start .
2 Within 10 seconds, press the push button again .
The LED blinks in a cycle of "long red – short green" to
indicate that calibration is about to start .
3 For a more reliable calibration, get out of the sensor's
measuring area now .
After 10 seconds the OccuSwitch DALI switches the
lights OFF .
After 2 seconds the OccuSwitch DALI takes a
measurement of the Light sensor to measure the light
level when the lights are OFF .
The OccuSwitch DALI then switches the lights ON at
100% .
After 10 seconds the OccuSwitch DALI takes a
measurement of the Light sensor to measure the light
level when the lights are fully ON .
The LED stops its visual indication and the luminaires
flash once indicating that calibration is completed .