Set Application Mode; Background Level - Philips OccuSwitch DALI LRM2070 User Manual

OccuSwitch DALI
User Guide
Page 34
4 .2 .8

Set application mode

The OccuSwitch DALI controller has 10 pre-defined
application modes . The default application mode is
Mode 1 (Cell office) . The IRT9090 can be used to set the
application mode .
1 Press the Mode button .
II
I / II
The LED on the transmitter starts to
BMS PL W/C
1 2 3
10% A 20% B 30% C
blink .
4 5 6
40% D 50% E 60% F
7 8 9
70% G
0
on o
min
2 Select the required mode by pressing
group
1...9 (for mode number 10 press 1
save
followed by 0)
con g mode
O)))
The LED will stop blinking, the mode is
link? mode? test 100 h
now set within the remote .
add
zone
% A-G 0
on/o
power up background IR group reset
3 Point the remote towards the
delay pir daylight RF channel
OccuSwitch DALI, and press the green
scene
Send button .
The remote sends all stored settings
(application mode, power-up state,
background lighting level and IR group) .
The luminaires will flash once to confirm the selection .
4 .2 .9

Background level

In some application modes, the light level of all outputs
is set to a "background" level if there is no movement
detection for 15 minutes . This background level is by
default set to 20% of the maximum output level, but can
be changed with the IRT9090 .
1 Press the Background % button .
II
I/II
The LED on the transmitter starts to
BMS PL W/C
1 2 3
10% A 20% B 30% C
blink .
4 5 6
40% D 50% E 60% F
7 8 9
70% G
0
on o
min
2 Select the background level (10% - 70%,
group
or "min . " ) .
save
The LED will stop blinking, the
con g mode
O )))
background level is now set .
link? mode? test 100 h
add
zone
3 Point the remote towards the
% A-G 0
on/o
power up background IR group reset
OccuSwitch DALI, and press the green
delay pir daylight RF channel
Send button .
scene
The remote sends all stored settings
(application mode, power-up state,
background lighting level and IR group) .
The luminaires will flash once to confirm the selection .
D Note
The "Prolong time (background period)" is defined by
the application mode and cannot be changed .