Fitting The Cover Plate - ABB A145-M56 Operation Manual

Operation Manual / 4 Product description / A130-M.. - A145-M..
9 Taking out of operation at short notice
9.4

Fitting the cover plate

Remove turbocharger (see chapter Removal and installation).

Gas outlet casing removed

Fit the turbine casing with the gas outlet casing into the gas pipe again.

Attach the cover plate (see following section).

Gas outlet casing not removed

Fit the turbine casing into the gas pipe and on the gas outlet casing again.

Attach the cover plate (see following section).

Figure 58: Fitting the cover plate
Make sure that the oil connections in the bracket are equipped with gaskets.

1. Close opening in turbine casing (51000) with cover plate (01).
2. Thoroughly clean the fastening strips (51002) before assembly.
3. Coat the threads of the studs (51006) with high-temperature grease.
4. Fasten cover plate (01) to turbine casing (51000) with fastening strips (51002), Verbus
Ripp® washers (51003) and nuts (51007) and screw to bracket.
© Copyright 2017 ABB. All rights reserved. HZTL4031_EN
Page 109 / 121
Revision E January 2017