Kenwood DDX396 Instruction Manual page 43

Settings Settings
<Speaker/X'over>
Crossover network mode settings
(Only for DDX396/DDX419BT)
Before making any settings for the speakers and
crossover frequency, select the appropriate crossover
network mode according to the speaker system (2-way
speaker system or 3-way speaker system).
• Connecting 3-way speakers with 2-way crossover
network mode selected may damage the speakers.
1
Display the source/option selection screen.
On the Home screen, touch as follows:
2
Put the unit in standby.
On the source/option selection screen, touch as
follows:
3
Press the following buttons/knob on the
monitor panel at the same time to display
the <X'over Network> screen.
• DDX396: MENU button and ATT knob
• DDX419BT: MENU button and CAM button
4
Select the crossover network mode.
[2way] Select this when connecting speakers
in a 2-way system (front/rear).
[3way] Select this when connecting speakers
in a 3-way system (tweeter/mid
range/woofer).
A confirmation message appears. Touch [Yes] to
confirm.
Setting the speakers and crossover
frequency
1
Select a car type ( 1 ), select the location
of the speakers ( 2 ), then display the
<Speaker Select> screen (
• Only for DDX396/DDX419BT: Speaker location
selection is available only when <X'over
Network> is set to [2way].
2
Select the speaker type (
of the selected speaker (
the <X'over> screen (
• If a speaker is not connected, select <None>.
• When setting the front speakers, also select the
speaker size for <Tweeter>.
3 ).
1 ), select the size
2 ), then display
3 ).
ENGLISH 41