Installing Input And Output Panel Bracket; Intrusion Switch; Removing The Intrusion Switch - Dell Precision 5820 Tower Owner's Manual

Installing input and output panel bracket

1. Insert the input and output(I/O) panel into the metal bracket.
2. Replace the screws to secure the I/O panel bracket to the I/O panel.
3. Install the:
a. front input and output panel
b. front input and output bezel
c. 5.25 inch ODD bracket
d. front bezel
e. side cover
4. Follow the procedure in

Intrusion switch

Removing the Intrusion switch

1. Follow the procedure in
2. Remove the:
a. side cover
b. front bezel
c. 5.25 inch ODD bracket
3. To remove the intrusion switch:
a. Disconnect the intrusion cable [1] from the I/O module.
b. Remove the screw [2] that secures the intrusion switch to the chassis.
c. Lift the intrusion switch and remove it from the chassis.
NOTE: The system will not power on without the intrusion switch installed.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components 47