Mitsubishi Electric A800-GF Instruction Manual page 109

Common specifications
Protective
function
Protective/
warning
function
Warning
function
Surrounding air
temperature
Surrounding air humidity
Storage temperature

Atmosphere
Altitude/vibration

Available only when a vector control compatible option is mounted.

In the initial setting, it is limited to 150% by the torque limit level.

Temperature applicable for a short time, e.g. in transit.

This protective function is not available in the initial status.
108
SPECIFICATIONS
Overcurrent trip during acceleration, Overcurrent trip during constant speed, Overcurrent trip during deceleration or stop,
Regenerative overvoltage trip during acceleration, Regenerative overvoltage trip during constant speed, Regenerative
overvoltage trip during deceleration or stop, Inverter overload trip (electronic thermal relay function), Motor overload trip
(electronic thermal relay function), Heat sink overheat, Stall prevention stop, Loss of synchronism detection
fault detection, Lower limit fault detection, Output side earth (ground) fault overcurrent, Output phase loss, External
thermal relay operation , PTC thermistor operation

fault (control circuit board), PU disconnection, Retry count excess
CPU fault, Operation panel power supply short circuit/RS-485 terminals power supply short circuit, 24 VDC power fault,
Abnormal output current detection
circuit fault, Overspeed occurrence
fault , Brake sequence fault , Encoder phase fault
 
fault, Opposite rotation deceleration fault
output operation

Fan alarm, Stall prevention (overcurrent), Stall prevention (overvoltage), Electronic thermal relay function pre-alarm, PU
stop, Speed limit indication (output during speed limit)
host error, Home position return setting error
setting error , Operation panel lock

power supply operation, Continuous operation during communication fault, Load fault warning
0°C to +50°C (non-freezing) (LD, ND, HD ratings)
0°C to +40°C (non-freezing) (SLD rating)
95% RH or less (non-condensing) (With circuit board coating (conforming to IEC60721-3-3 3C2/3S2), IP55 compatible
models)
90% RH or less (non-condensing) (Without circuit board coating)
-20°C to +65°C
Indoors (without corrosive gas, flammable gas, oil mist, dust and dirt, etc.)
Maximum 2500 m (For the installation in an altitude above 1000 m, derate the rated current 3% per 500 m.)
2
• 2.9 m/s or less at 10 to 55 Hz (directions of X, Y, Z axes)
, Option fault, Communication option fault, Parameter storage device

, Parameter storage device fault (main circuit board),

, Communication fault (inverter), Analog input fault, USB communication fault, Safety

, Speed deviation excess detection

, 4 mA input fault

, Internal circuit fault, Magnetic pole position unknown

, Parameter copy, Safety stop, Maintenance timer 1 to 3

, Home position return uncompleted

, Password locked , Parameter write error, Copy operation error, 24 V external
 
, Signal loss detection , Excessive position
 
, Pre-charge fault , PID signal fault
 
, External fault during

, Home position return parameter

, Upper limit

, Option

, USB
