Conversion Table - Komatsu PC88MR-10 Shop Manual

Hydraulic excavator

Hide thumbs Also See for PC88MR-10:

Table of Contents

Conversion table

Method of using the conversion table

The unit conversion table enables the simple conversion in the figures between the different units. For

further details of the method of use of the conversion table, see the examples given below.

Example: Method of using the conversion table to convert a unit from millimeters to inches

Conversion of 55 mm into inches

1. Locate the number 50 in the vertical column at the left side, take this as (A), and then draw a horizontal

line from (A).

2. Locate the number 5 in the row across the top, take this as (B), then draw a vertical line down from (B).

3. Take the point where the 2 lines cross as (C). This point (C) gives the value when converting the unit from

millimeters to inches. Therefore, 55 mm = 2.165 in.

Conversion of 550 mm into inches

1. The number 550 does not appear in the table, so divide it by 10 (move the decimal point one place to the

left) to get 55 mm.

2. Then convert 55 mm to 2.165 in by the same procedure as above.

3. The original value (550 mm) was divided by 10, so multiply 2.165 inches by 10 (move the decimal point

one place to the right) to get the original value. This gives 550 mm = 21.65 in. Therefore, 550 mm = 21.65

Millimeters to inches

(ALL-2150-931-A-00-A)

Foreword, safety and general information

00 Index and foreword

(Rev. 2012/10)

1 mm = 0.03937 in

Table of Contents