Adjusting Rearview Camera Angle - Komatsu PC88MR-10 Shop Manual

Adjusting rearview camera angle

a Adjust the camera so that persons in area (W) of
1 meter around the rear of the machine can be
seen by the machine monitor in the operator's
cab.
If the image displayed on the monitor is out of
position, adjust the installation angle of camera (1).
Adjusting
(PC88MR-Q162-270-K-00-A)
1. Remove cover (3) by inserting flat-head
screwdriver [1] in the hole in cover (3) and
pressing the internal claw.
a The claw of cover (3) is made of plastic, so
be careful not to break it when removing.
2. Remove bolts (4) (2 places).
3. Remove cover (2).
PC88MR-10
(PC88MR-Q162-360-K-00-A)
4. Loosen mounting bolts (5) of camera (1), and
adjust camera installing angle (A) so that the
side of camera matches the edge of bracket (B).
Angle (A): 48 deg. (+2 deg. /0)
a A part of the machine is displayed on the
monitor screen.
Adjust the image area of the counterweight
displayed on the monitor screen to 10 to 15%.
5. After adjusting, tighten bolts (5).
Camera mounting bolt:
11.8 to 14.7 Nm {1.2 to 1.5 kgm}
30 Testing and adjusting
Electrical system
30-125