Table of Contents
Advertisement
FCC RULES COMPLIANCE
The equipment covered in this manual has been tested and found to comply with the
limits for a Class A digital device, according to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult Siemens Customer Service for help.
Modifications not expressly approved by the manufacturer could void the user's authority
to operate the equipment under FCC rules.
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter must follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must be at least 8 inches (20 cm) from the user and
must not be co-located or operating in conjunction with any other antenna or transmitter.
All antenna installation and servicing are to be performed by qualified technical personnel only.
When servicing or working at distances closer than 7 feet (2 meters), ensure the transmitter has
been disabled. Depending upon the application and the gain of the antenna, the total composite
power could exceed 100 watts EIRP. The antenna location should be such that only qualified
technical personnel can access it, and under normal operating conditions no other person can
come in contact or approach within 7 feet (2 meters) of the antenna.
COM-00-21-04
Version No.: A.1
RF EXPOSURE WARNING
iii
OCTOBER 2021
Advertisement
Table of Contents
