Table of Contents
Advertisement
_________________________________________________________________________________________________________
3.5.4 GPS Antenna
The optional antenna recommended for use with the Airlink Venus is a Trimble Bullet III GPS
antenna (or equivalent) as shown in Figure 3-7. This antenna requires 5 VDC which is supplied
through the Airlink Venus GPS connector.
The Trimble antenna has a TNC female connector. The cable from the Airlink Venus should be
a single run TNC-Male to SMA-Male RG-8X cable (without additional connectors or adapters)
and no longer than 75 feet as the antenna is an active 5 VDC device with power supplied over
this interface. Lower loss cable such as RG-8 can be used for extended length if needed.
The antenna should be installed with a clear view of the sky. The base of the unit is threaded to
allow it to be mounted on a hollow conduit.
COM-00-21-04
Version No.: A.1
Feature
Prime Power
Power Consumption
Gain
Output Impedance
Frequency
VSWR
Axial ratio
Noise
Bandwidth (10dB RL)
Out of Band rejection
Azimuth coverage
Elevation coverage
ESD
Figure 3-7 Trimble Bullet III GPS Antenna
RF cabling should be installed by properly trained and qualified
personnel in compliance with all State and Local codes.
3.3V
3.3V DV (±10%)
<20mA
28dB ± 3dB
GPS L1 1575.42 ±1.023MHz
90°: 4dB maximum;
10°: 6 dB maximum
fo=1575.42MHz
fo ±20 MHz: 7dB min
fo ±30 MHz: 12dB min fo
±50 MHz: 20 dB min fo
±100MHz: 30dB min
360° (omnidirectional)
0°-90° elevation
(hemispherical)
IEC 61000-4-2
NOTE
3-9
INSTALLATION
5.0V
5.0V DV (±10%)
<30mA
30dB ± 3dB
50Ω
2.0 maximum
3.0dB (typical)
50MHz (min)
0°-90° elevation
(hemispherical)
OCTOBER 2021
Advertisement
Table of Contents
