Table of Contents
Advertisement
_________________________________________________________________________________________________________
3.5.6 Connection Summary
Connection/Switch
LCD
Ground Post
Input - / +
Reset DC/LED Power
Indicator
GPS
RF1 50 Ω
RF2 50 Ω
Serial
Console
Eth1
Eth2
COM-00-21-04
Version No.: A.1
Table 3-1 Connection Summary
LCD screen shows system status
Connection to protective earth ground. Use a #10-32 thread locking nut
torque to 8 inch-pounds with a 3/8" wrench.
The Radio is supplied with a mating screw terminal plug, Phoenix P/N: 1777989,
that needs to be wired.
DC power input 18-60 VDC, 2A minimum. Tighten screw terminal locking screws
using a screwdriver to prevent disconnection of plug from the socket.
Ensure correct polarity when wiring DC power supply to screw terminal
plug. Power supply (not provided) must meet electrical requirements and
State and local code requirements for use application. Installation by
qualified personnel only.
This is a dual-purpose DC power reset switch with a built-in LED power indicator.
SMA female connector torque to 5 inch-pounds with 5/16" open-end wrench for
an optional GPS antenna.
50Ω N-Type female connector for RF input/output from the antenna. Torque hex
connector to 15 inch-pounds with 5/8" open-end wrench.
Never energize the Airlink Venus radio without a 50 Ohm (4 Watt min) load
(or antenna) on the RF connector.
50Ω N-Type female connector for RF input/output from the antenna. Torque hex
connector to 15 inch-pounds with 5/8" open-end wrench.
Note: RF2 is not supported at present and is reserved for future use (RFU).
RJ45 8-pin socket wired using the Cisco interface specification for RS232 serial
data.
RJ45 8-pin socket wired using the Cisco RS232 serial interface specification for
console access.
RJ45 8-pin socket for CAT5/6e Ethernet 10/100 Base-T cable interface.
RJ45 8-pin socket for CAT5/6e Ethernet 10/100 Base-T cable interface.
3-11
Application
INSTALLATION
OCTOBER 2021
Advertisement
Table of Contents
